4x4 with g4

[abd al darweesh]

hi everybody . i have nissan r32 it's all wheel . and I have g4 xtreme . can anyone tell me what i have to do for the four wheel wiring and setting . thanks.

[Top Tune NZ]

you will need to send a tps signal to the 4wd ecu to make it work correctly

where are you from i have done many of these

drop me a email [email protected]

[abd al darweesh]

hi.

i am from saudi arabya

 Unfortunately, the answer to your question late
You must be said that the tps wire to the 4wd computer

But I have seen in the map in the factory wiring daigram that there are three wires wires

1-is rpm wire

2-tps (-)

3-tps(+)

The problem is that the positive terminal of the third cycle where you get it .can i take it from Auxiliary Outputs.

or  do theye mean tps (+) 0-5v

pleas help me if you can Thanks again

best regards

[Simon]

RPM input can be a tacho out from the ECU it will be ok to share this.

TPS (-)  I suspect will be a signal ground.

TPS + would be the signal.