ericsiewkk Posted March 3, 2016 Report Share Posted March 3, 2016 anyone have the diagram to wire up 6 wire mitsubishi idle control valve to g4+ xtreme? Quote Link to comment Share on other sites More sharing options...
Scott Posted March 7, 2016 Report Share Posted March 7, 2016 I don't have a wiring diagram for the mitsubishi, but using a multimeter and our standard 6 pin idle stepper diagram you should be able to work it out. The resistance between the coil 'pairs' will be approximately double the resistance between the +14V and one end of the coil pair.On our EVO 4-8 plug-in ECUs coil pair 'A' are on pins 17 and 4, while coil pair 'B' are on pins 18 and 5. These numbers relate to the numbering of the ECU connector. Adturb and Boosted4g63 2 Quote Link to comment Share on other sites More sharing options...
ericsiewkk Posted March 7, 2016 Author Report Share Posted March 7, 2016 thanks scott! can we remove the 2 middle +12v power from the iac valve? with haltech ecu we are advised to remove the 12v for better control? Quote Link to comment Share on other sites More sharing options...
Scott Posted March 8, 2016 Report Share Posted March 8, 2016 On a 6 terminal stepper motor you will want the +14V ignition switched connection connected. Quote Link to comment Share on other sites More sharing options...
Walter Cassar Posted September 30, 2017 Report Share Posted September 30, 2017 Hi with the above reference to the ISC Aux 5 and 6 and 7 and 8 how should they be wired to the isc....they can be switch polarity etc? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.