Cake Posted March 27, 2016 Report Share Posted March 27, 2016 I have just noticed under the R menu (Runtime Values) that my prime fuel ms is 18ms cold start and was highlighted in red. After a few stops and starts it seems to go down to 5ms but from what I read 14v @ 3bar pressure it should be under a 1ms. What are the possible causes? Quote Link to comment Share on other sites More sharing options...
Scott Posted March 29, 2016 Report Share Posted March 29, 2016 The pre-crank prime value will depend on what the current table value is. This is often based on the current ECT and TPS. When it is highlighted red that is because the 'High Error Value' is set is set this way in your PCLink. You can adjust the warning and error level in the setup of the parameter. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.