RH9 GTR Posted November 25, 2016 Report Share Posted November 25, 2016 Hi , I am trying to log wideband - it is connected to An Volt 3 - it is showing live values butwhen i try to log , it says NO DATA. I tried to log all lambda and wide band parameters but i see no data.Can anyone help out ?Thanks. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 25, 2016 Report Share Posted November 25, 2016 If you dont mind posting your map and log I will take a quick look to see if I can spot anything. Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted November 26, 2016 Author Report Share Posted November 26, 2016 Is there any possibility that wide band logging works in PC logging and does not work in ECU logging ?I was attempting to log it through ECU logging. Here is the map. V88 wire in board. Hiz440+stock cold start.pcl Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 28, 2016 Report Share Posted November 28, 2016 You are on a very old firmware version, 4.7.* According to the help file, the Wideband1 parameter was not logged prior to version 4.9.9.Update to the latest version and you will be good. Scott 1 Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted November 28, 2016 Author Report Share Posted November 28, 2016 Hi Adam,I am using 4.10.2 firmware.I am logging wideband now but values are way off. Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 28, 2016 Report Share Posted November 28, 2016 I am using 4.10.2 firmware.I am logging wideband now but values are way off. The map you posted shows 4.7.1? If you post a log and your latest .pcl, I will take a quick look to see if I can see your problem.picture share Quote Link to comment Share on other sites More sharing options...
RH9 GTR Posted November 28, 2016 Author Report Share Posted November 28, 2016 Adamw i think the ecu internal firmware is not updated.The Vipec software i am using is 4.10. The map i posted is the actual map i am using.Here is the log .. Log 27-11-16 5;42;33 pm.llg Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 28, 2016 Report Share Posted November 28, 2016 The log confirms you are still on an old firmware 4.7.1. This is different to the PC software version. Read the help file about firmware update. Also read the release notes since version 4.7.1 and note any important ones(usually highlighted in orange text). One I remember around 4.9.9 is you have to delete all ecu logs before doing the update. You are missing out on many feature enhancements and bug fixes so you should upgrade. Your AFR being off is most likely calibration or wiring related but update your firmware first because there were some bugs with wideband average parameter in earlier versions. Quote Link to comment Share on other sites More sharing options...
jervies1 Posted December 10, 2016 Report Share Posted December 10, 2016 I had this same issue on old firmware, could never populate the mixture table from ecu log. New firmware fixes that issue and gives you much much better logging capabilities. Dont use the vipec firmware use the pclink and link firmware Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.