MR2 Rev2 Loom for LinkPlius G3 ecu

[Tomas_St]

hi guys i need help with loom. i need make loom for Link g3 plus ecu for my mr2 rev2 but little bit scare to do something wrong and burn or damage my ecu . i got photo with both pinouts and some one edit that picture. add arrows  on correct pining  i will be so happy. Thank you  

[Scott]

Link produce a plug-in ECU for the MR2 rev 2-3. I recommend using the pinout and pin function charts for this ECU to help you allocate the pins from the factory connector to the G3 Linkplus.

Here are the pinout and pin function charts:

r

So for example 'ISC close solenoid' would go to Aux Output 1, which is pin 5 on the MR2 connector and 'Aux 1 (Orange/Black)' on the G3 Linkplus.

Make your self a spreadsheet to help organise all the pin connections, then upload it here and someone can check it.

Scott

[Tomas_St]

Link produce a plug-in ECU for the MR2 rev 2-3. I recommend using the pinout and pin function charts for this ECU to help you allocate the pins from the factory connector to the G3 Linkplus.

Here are the pinout and pin function charts:

r

So for example 'ISC close solenoid' would go to Aux Output 1, which is pin 5 on the MR2 connector and 'Aux 1 (Orange/Black)' on the G3 Linkplus.

Make your self a spreadsheet to help organise all the pin connections, then upload it here and someone can check it.

Scott

Thank you very much Scott thats  actually what i been looked for 

Edited February 11, 2017 by Tomas_St