simonjob Posted September 10, 2017 Report Share Posted September 10, 2017 good afternoon I am trying to link the dash to the ecu but cant get them to talk to each other its connected via can networks high and low any help would be good Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 12, 2017 Report Share Posted September 12, 2017 Hi Simon,Sorry I missed your post here, the last couple of days have been busy. If you still have no comms can you give us a bit more info. Maybe attach your ECU and dash config files and I'll take a look. Quote Link to comment Share on other sites More sharing options...
simonjob Posted September 13, 2017 Author Report Share Posted September 13, 2017 here is a pic of the setup in link and aim simons s14.pclr Quote Link to comment Share on other sites More sharing options...
simonjob Posted September 15, 2017 Author Report Share Posted September 15, 2017 Did the pics help or fo i need to get more info on it? Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 16, 2017 Report Share Posted September 16, 2017 (edited) I think you might have the wrong ECU stream selected in the AIM software. Usually the "CAN Bus Base" is the one you want to use. The think the "G4" one that you have chosen is the old serial stream. Edited September 16, 2017 by Adamw Quote Link to comment Share on other sites More sharing options...
simonjob Posted September 16, 2017 Author Report Share Posted September 16, 2017 Ok i will give that a go and see if it works Quote Link to comment Share on other sites More sharing options...
simonjob Posted October 3, 2017 Author Report Share Posted October 3, 2017 ok i have it working now thanks for the help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.