Coolkit Posted March 4, 2018 Report Share Posted March 4, 2018 Hi Newbie here. I am using link g4+ plug and play. How can I use the signal from AEM afr gauge connect to g4+ , so that the g4+ can read afr and to gerther with AEM afr gauge is working. Kindly provide guidance . Thank you. Quote Link to comment Share on other sites More sharing options...
ClintBHP Posted March 4, 2018 Report Share Posted March 4, 2018 http://aemelectronics.com/files/instructions/30-4110 Digital Wideband UEGO Gauge.pdf According to this you need to take the white wire and connect that to one of your spare ANVolt Inputs, you may need a XLS Expansion Loom for this, or if your vehicle originally had a NB Oxy you can connect to that wire. Quote Link to comment Share on other sites More sharing options...
Coolkit Posted March 5, 2018 Author Report Share Posted March 5, 2018 Still don't get it..... Using my original o2 cable white colour connect to aem which cable.... The afr I am going to purchase : http://www.aemelectronics.com/?q=products/gauges/digital-gauges/x-series-wideband-uego-afr-sensor-controller-gauge Quote Link to comment Share on other sites More sharing options...
Simon Posted March 5, 2018 Report Share Posted March 5, 2018 You need to connect the output of the AEM gauge to the ECU via a free AN volt input or via the CAN bus. If using the 0-5V output of the gauge this could be connected to the original narrow band O2 input (Pin 56 on ECU plug) if you wish or any other volt input for example one on a XS loom. If using CAN then you need to connect CAN L and H from the gauge to the CAN connector on the ECU (A CANPCB cable and CANF plug needed) For both the ECU will then need to be configured to suit. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.