azmak Posted August 28, 2018 Report Share Posted August 28, 2018 Hello everyone. I am using AIM MXS Strada for the Nissan GTR LINK plug-in. In this case, PC - LINK can not communicate. If you disconnect the CAN connector of MXS Strada, PC - LINK can communicate. This is inconvenient. Is there a solution? Quote Link to comment Share on other sites More sharing options...
JMP Posted August 29, 2018 Report Share Posted August 29, 2018 remove the additional wires from the CAN connector that goes to the ECU, so you only have the two CAN wires. Quote Link to comment Share on other sites More sharing options...
azmak Posted August 29, 2018 Author Report Share Posted August 29, 2018 まず、パソコンを「USB⇒」に接続しました。AIMMXLを「CAN/RS232」に接続しました。その場合、PC〜LINKECU〜AIMは同時に接続できませんでした。 AIMMXLを「CAN/RS232」に接続しました。PCを「CAN2/OBD」に接続しましたが、通信できませんでした。 正しく接続する方法を教えてください。 Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 29, 2018 Report Share Posted August 29, 2018 Extract the brown, grey & yellow wires out of the white plug (or snip the wires). Only green and white are used for CAN. Our you shorten the CAN DASH cable so that the RS232 wires are less than about 200mm long then it wont interfere with PC Comms. Note this problem is because you are using the CANDASH cable which is not the correct cable for this (despite its poorly chosen name it also has the RS232 wires inside). For a CAN only device connection we recommend using just the CANF plug and your own twisted pair wires for CAN H/CAN L. Quote Link to comment Share on other sites More sharing options...
azmak Posted August 29, 2018 Author Report Share Posted August 29, 2018 LINK ECUに接続されているUSBケーブルは使用できませんか?RS232ケーブルが必要ですか? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 29, 2018 Report Share Posted August 29, 2018 No, Im talking about the cable connected to your dash, not the USB PC cable. The USB PC cable is perfectly fine. You need to change the wiring to the dash. Quote Link to comment Share on other sites More sharing options...
azmak Posted August 29, 2018 Author Report Share Posted August 29, 2018 I'll try. I appreciate your guidance. Thank you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.