evo_gerard Posted October 18, 2018 Report Share Posted October 18, 2018 good day, I'm in the process of selecting an ecu to run my (soon to be built) SR20vet project. i am gravitating towards the G4+ storm black ecu. but i have a question? does storm ecu have the ability to do 4D/5D tuning? i'm thinking of using 4D/5D compensation for my water/meth kit that's on the vehicle. can the storm ecu do this? Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 18, 2018 Report Share Posted October 18, 2018 Yes, any of the G4+ ECUs have the 5D tables for fuel and ignition, also up three separate boost tables to switch between or you can interpolate between two boost tables. Quote Link to comment Share on other sites More sharing options...
evo_gerard Posted October 18, 2018 Author Report Share Posted October 18, 2018 thanks Adam for the quick reply, i have one more question. so even thou i haven't purchased the ecu yet, i went ahead and downloaded the pclink software to get familiar with it. when i load up the sample G4+ storm black configuration i see the option to enable the 4D mode and set the table activation but i dont see the actual map itself after i turned the the 4D mode on? Am i following the correct procedure? Also if i load another sample configuration eg the "fury" or the "evo 4-8" and i enable the 4D mode i usually get a prompt and the table appears. Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 18, 2018 Report Share Posted October 18, 2018 Possibly just looking in the wrong place? Pic below to make it clearer. The other possibility is our Storm example base map is actually quite busy, with a lot of "junk" enabled (I think this map was from our XR6 test car which normally uses a Thunder). The Storm has 20 "table slots". Most of the basic fundamental control stuff such as fuel/ign tables etc have their own dedicated tables but many of the less commonly used functions will use one of these general purpose table allocations. So if all of those tables are allocated it wont allow you to enable more. You can check whats assigned down the bottom of the ECU settings tree in the table allocations menu. From memory the Storm base map has about 17 of the 20 already used up. It is very unlikely to need all 20 with a typical 4cyl set up. Quote Link to comment Share on other sites More sharing options...
evo_gerard Posted October 18, 2018 Author Report Share Posted October 18, 2018 thanks again Adam! you provide A1 support! could i get another version of the G4+ storm black sample config? below is what i'm getting when i enable it on my sample file G4+ Storm Black Sample.pclr Quote Link to comment Share on other sites More sharing options...
Adamw Posted October 19, 2018 Report Share Posted October 19, 2018 As I mentioned above the map you are using already has all 20 table allocations used up. This is because it is from an engine with 6cy individual knock control, 2 VVT cams etc, multiple boost tables etc. In the attached map I have turned off some of that stuff so you will now be able to enable a 4D table G4+ Storm Black.pclr Quote Link to comment Share on other sites More sharing options...
evo_gerard Posted October 19, 2018 Author Report Share Posted October 19, 2018 thanks Adam! all this is new to me so sorry if i'm coming across as nagging. your support is A1 as usual and i am very grateful for it! thanks you again and enjoy your day! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.