FunJam Posted May 12, 2021 Author Report Share Posted May 12, 2021 EGT should be shown in CAN TC Cyl 1...4? I also configured cyl 5..8 for just in case, but no result. Turned ECU off and on. 12 V and ground in Ecu Master EGT is OK Tryed also give a little heat to thermocouple, no result. I did load the .lcs file. Should it be shown in this window? If I try to load it again it gives me this. Can I check somehow, if the problem is the connection, or the device Jani Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 12, 2021 Report Share Posted May 12, 2021 Please attach your map. You have nothing set up on stream one in your pic above. Quote Link to comment Share on other sites More sharing options...
FunJam Posted May 13, 2021 Author Report Share Posted May 13, 2021 G4+Busa Methanol 4 Lisätty ahdon ohjaus.pclr Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 13, 2021 Report Share Posted May 13, 2021 Try this one. 1846791508_G4BusaMethanol4Listtyahdonohjaus CAN change.pclr Quote Link to comment Share on other sites More sharing options...
FunJam Posted May 14, 2021 Author Report Share Posted May 14, 2021 Still does not work... Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 14, 2021 Report Share Posted May 14, 2021 Why have you got TC1-4 in stream 2 again? It wasnt like that in the file I done. If you look in the ecumaster software, is the bit rate and ID's set to the defaults like below. Does live data show in their software? Quote Link to comment Share on other sites More sharing options...
FunJam Posted May 14, 2021 Author Report Share Posted May 14, 2021 No, it wasn't, I added it afterwards, when it didn't work and I did try to figure out what to do. Confused between channel and stream. But same was in stream 1. Setup parameters were just like that, live is ok in all 4 thermocouples. I checked the wiring again also. +12 and ground are obviously OK , CAN2 H (grey/purple) and L (grey/white) are rounded with each other, CAN bus end resistor OK, connection to EcuMaster with short wiring to correct terminals OK. Is this the correct CAN BUS ? CAN 2? F*ck.... I'll get back later... :-) Quote Link to comment Share on other sites More sharing options...
FunJam Posted May 14, 2021 Author Report Share Posted May 14, 2021 And that solved it... I used the wrong CAN module. Sometimes I feel bit stupid, but I don't care. Dyno on sunday, now everything seems to be ready for that. Thanks Adam! Again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.