alexjohn Posted December 4, 2018 Report Share Posted December 4, 2018 How to setup quick tune ?i use innovate mtx-l digital air/fuel and wiring? Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted December 4, 2018 Report Share Posted December 4, 2018 Connect the Yellow wire to a spare Analog input on the Storm, and then select Lambda 1 from the analog input menu. Choose Cal Table 4, and then enter in the following bold calibration values (assuming it is set to factory defaults) the YELLOW (Analog out 1) and/or BROWN (Analog out 2) can be connected to the analog inputs of other devices such as data loggers or ECUs. If either one or both of these wires are not being used isolate and tape the wire(s) out of the way. The default analog outputs are as follows: Analog output one (yellow) is 0V = 7.35 AFR and 5V = 22.39 AFR HTH, Richard. Quote Link to comment Share on other sites More sharing options...
alexjohn Posted December 17, 2018 Author Report Share Posted December 17, 2018 Hi richard hill already to setup for quick tune but have the fault code 16? Mtx-l digital air/fuel yellow wire connet to An volt3... Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted December 17, 2018 Report Share Posted December 17, 2018 That might be because some Lambda controllers output 5V on power up, before the sensor is active. Set error high to 5V to disable, but monitor the voltage to see if this is the case. Also, input value B should be 5V Quote Link to comment Share on other sites More sharing options...
Ducie54 Posted December 17, 2018 Report Share Posted December 17, 2018 You also need to swap the output units from lambda to afr. Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted December 17, 2018 Report Share Posted December 17, 2018 the only units in the Cal are Lambda so for 14.7 Stoich :- 7.3=0.497 22.39=1.523 Quote Link to comment Share on other sites More sharing options...
alexjohn Posted December 18, 2018 Author Report Share Posted December 18, 2018 Tq richard the setting is ok already Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.