Fotis Posted February 28, 2019 Report Share Posted February 28, 2019 Hi everyone trying to figure out the triggers on a TOYOTA 4EFE to run Link ecu. No crank sensor. Only Cam sensor which has 4 teeth and 1 teeth a bit outside of the shaft here is a picture to understand. So with my understanding i will connect them and set the as Trigger 1: Reluctor-multi tooth -4teeth Trigger 2: Same with 1 teeth Is this correct? And how will the engine sync since there isn't a crank sensor,or am i wrong ? Should i just add an aftermarket crank trigger wheel and save me from all that trouble? Quote Link to comment Share on other sites More sharing options...
Kenian Posted March 1, 2019 Report Share Posted March 1, 2019 I beleive that this is correct - just like a sr20DE i setup recently both trig 1 and trig 2 are driven off the CAS that is located inside the distributor cap and no crank trigger is needed. Ive just had a quick google on trigger setup for this engine and there seems to be alot of info on Megasquirt formums regarding trigger wiring etc. You can most likely get your answers off that. Fotis 1 Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 1, 2019 Report Share Posted March 1, 2019 You have it mostly right. 4 tooth sensor goes to trig 1, single tooth sensor goes to trig 2. Both are reluctors. Set trigger mode to "1 tooth per TDC" Set trig 2 sync mode to "cam pulse 1X" and sync position according to where the single tooth is located. Fotis 1 Quote Link to comment Share on other sites More sharing options...
Fotis Posted March 1, 2019 Author Report Share Posted March 1, 2019 Awesome thanks guys!! Quote Link to comment Share on other sites More sharing options...
Fotis Posted April 18, 2019 Author Report Share Posted April 18, 2019 Hi i have set all the parameters. I have problem with the wiring of the triggers and my ignition drive. I have managed to get the trigger 1 signal but i dont know which wire should i get for trigger 2 any ideas? 4tooth dizzy. Thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 18, 2019 Report Share Posted April 18, 2019 Quote Link to comment Share on other sites More sharing options...
Fotis Posted April 18, 2019 Author Report Share Posted April 18, 2019 G- G+ trig 1 Ne- Ne+ trig 2? What about the ignition drive? Quote Link to comment Share on other sites More sharing options...
Joris Posted August 24, 2020 Report Share Posted August 24, 2020 On 4/18/2019 at 12:17 PM, Fotis said: Hi i have set all the parameters. I have problem with the wiring of the triggers and my ignition drive. I have managed to get the trigger 1 signal but i dont know which wire should i get for trigger 2 any ideas? 4tooth dizzy. Thanks HI, Have you managed to find a solution? Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 24, 2020 Report Share Posted August 24, 2020 6 hours ago, Joris said: HI, Have you managed to find a solution? You would be best to ask your own question. What engine do you have? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.