Woody Posted March 7, 2019 Report Share Posted March 7, 2019 Hi all , i need to get a proper rpm signal to my Dyno software , it supports OBD and works spot on with this , the inductive and capacitive clamps are not that brilliant and very spikey. My thinking is to use the CAN output from G4+ to send rpm signal to my OBD input . Any ideas , thanks in advance . Cheers Keith Quote Link to comment Share on other sites More sharing options...
ClintBHP Posted March 7, 2019 Report Share Posted March 7, 2019 Hi Keith, you can get Engine Speed on PID0C and vehicle speed on PID0D for setting the run up via OBD, select the CAN port select user defined, select the highest speed your dyno will read OBD in, usually 500kbs, and then check the ISO 15764-4 checkbox on the right. Quote Link to comment Share on other sites More sharing options...
Woody Posted March 13, 2019 Author Report Share Posted March 13, 2019 On 3/7/2019 at 11:12 PM, ClintBHP said: Hi Keith, you can get Engine Speed on PID0C and vehicle speed on PID0D for setting the run up via OBD, select the CAN port select user defined, select the highest speed your dyno will read OBD in, usually 500kbs, and then check the ISO 15764-4 checkbox on the right. Thanks Clint , will give it a go.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.