AlexJ Posted April 26, 2019 Report Posted April 26, 2019 I have open loop boost control setup. two duty cycle tables with a DI switching between them. I want to only run the high boost table when the DI switch is on AND in 3rd gear and above. Is it possible to use boost per gear trim for this or is there some way to combine the DI and gear as the logic to switch to the high boost DC table. Quote
Adamw Posted April 26, 2019 Report Posted April 26, 2019 2 hours ago, AlexJ said: or is there some way to combine the DI and gear as the logic to switch to the high boost DC table. This would be the best way to do it. Use a virtual aux to switch your table, the virtual aux conditions will be DI # = on and Gear > 2. In example below my switch is on DI5. Quote
AlexJ Posted April 27, 2019 Author Report Posted April 27, 2019 fantastic! that is exactly what I'm after. Quote
AlexJ Posted May 10, 2019 Author Report Posted May 10, 2019 Just to update. I used this at the track yesterday and it worked perfectly. Thanks Adam Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.