Handy1222man Posted May 3, 2019 Report Share Posted May 3, 2019 I have a jdm Subaru Ej20g in my sand rail. What adjustment do I need to make on my g4+ monsoon ecu after changing my injectors from stock 380cc to 550cc? Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 3, 2019 Report Share Posted May 3, 2019 Are you using traditional fuel equation mode or modelled? Quote Link to comment Share on other sites More sharing options...
Handy1222man Posted May 3, 2019 Author Report Share Posted May 3, 2019 Traditional Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 3, 2019 Report Share Posted May 3, 2019 Ok, so your new injectors are about 45% bigger, so we need to reduce the pulsewidth by about 45% to end up with the same fuel volume injected. The quickest way to do this is left mouse click on the top left corner of the fuel table (this selscts the whole table), then on your keyboard type in "-45%" and hit enter. This likely wont get it perfect due to different deadtimes etc but it will get it in the ballpark. Quote Link to comment Share on other sites More sharing options...
rickie Posted May 29, 2019 Report Share Posted May 29, 2019 Is this still the way to do it? And should i also write in the new deadtime for the new injectors Quote Link to comment Share on other sites More sharing options...
neil brown Posted May 29, 2019 Report Share Posted May 29, 2019 I went from low impedance 650 to high impedance 565cc injectors and the fuel map was well out when driving on my ej20 turbo engine now been remapped and a lot better and feels like a different car and holds more boost than it ever did in mid range I would advise a retune ASAP to get the best out of it what mods are you running on the engine Quote Link to comment Share on other sites More sharing options...
Mozz Posted May 29, 2019 Report Share Posted May 29, 2019 First of all i dont have a subaru , but wondering if this is the way to change the fuel map when changing the injectors. i am changing from 510cc to 1000cc but i am going to change to e85 so my question is , do i need to change the map like - 10% for it , to find like a starting point for the mapping . best regards rick Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.