Pauly_FD
-
Posts
15 -
Joined
-
Last visited
Reputation Activity
-
Pauly_FD reacted to Adamw in G4x (firmware version 6.21.24) CAN bus issue with AEM Series X UEGO
Load your map back in to see if it’s still working
-
Pauly_FD reacted to Simon in G4x (firmware version 6.21.24) CAN bus issue with AEM Series X UEGO
The Lambda Sensor Control needs to be set as Link CAN
-
Pauly_FD reacted to Vaughan in G4x (firmware version 6.21.24) CAN bus issue with AEM Series X UEGO
Only Link devices show up in the CAN Devices tab.
If you are referring to CAN 1 not being connected CAN 2 is connected should be able to be used in parallel with the dash temperature stream. It also looks like you have overwritten Stream 1 with your Lambda setup which will cause issues for you, you should have your Lambda setup on Stream 2.
-
Pauly_FD reacted to Adamw in Very High Idle with Bosch E-throttle on a 2jzgte vvti
Drop the numbers in the idle base position table down to about 4% - this is how much the throttle is open for idle. You have ~40% in there now. Also in idle actuator settings change start up offset to 0% - this is how much extra the throttle is held open for start up, change the integral gain to 0.05 and change the max clamp to 8%. That should be closer.
