Hadzhonda

the back fires are due to your timing offset being incorrect, are you pressing enter to turn box blue, have you used a used a timing gun to see where you are at. I was like 50 off. Timing light is needed to get you close and then verify ecu timing vs real spark timing.

All sorted guys cheers for help. It didn't like the lithium. Swapped to s lead acid, no drama. 236 degree trigger offset and she idles sweet as a nut. I can tidy it up now. Really happy. VID_41640105_184137_477.mp4

I'm on a lithium battery, I will try swapping it out. Thanks for help. As soon as I crank it goes offline on laptop. I'll test at battery whilst cranking.

No it's an analogue signal, the form of v an ac sign wave buddy, Hall type goes 0 to 5v. That's digital. Inductive requires and analogue to digital converter circuit.

So.....I cannot get my trigger offset setup lol. Tried all sorts. Lots of coughs and pops but won't fire up lol. Trigger kit will only fit one way so that's okay, also my damn ecu keeps powering off on laptop, as i crank, so that's not helping either. Can't get zla scope pattern from it. I'll keep trying. Tried lots of different offsets to get close with no results yet. I'll keep trying.

That's an ac sign wave, not a digital signal. That's analogue. You have an inductive sensor.

Great progress tonight. Coils are firing when i test. Hopefully get car fired up and timing offset dialled in at weekend. i will give an update. I'm on the 98+ ecu but on an obd 93 car so had to mess about a bit but I think I'm there. I can't get the car to scope the triggers as the ecu powers down which is random.n I'll look into that. Ran fine prior to cop setup. Laptop loses ecu connection just as I crank and want to capture.

When I try and do a capture my ecu disconnects from laptop. Not sure why? Any ideas. Happy until i crank.

Made a cover this avy to hold coils in nicely I presume I'm using a20 and a21, a31 and a32 as the coil drivers? Cheers all.

Ah great stuff. As much info on your wiring and setup the better. That might help me also. I've yet to make my loom up. I need to order wire, I've got all the plugs, terminals, coil packs and sensors etc managed to get coils to fit nice with this valve cover too. Just got a carbon hold down plate to make.

Cheers for the reply, that's really helpful and I'm really happy with the product I've purchased. It's really well put together, but tbh, i wouldn't expect anything less. All of your products have a cast iron reputation for R&D, and knew this is the same. I will keep everyone updated and if it helps when I've done I'll upload my cal file to help others, along with my wiring etc end details step by step.

Any update on this just purchased the same kit.