stroker

We try swap ecu to another car and it's working fine I will recheck wiring We try swap ecu to another car and it's working fine I will recheck wiring

Wire-in Nissan tb48

So problem on the wiring !?

hi i have a problem starting nissan tb48 it's work great on G+ trigger scope here TriggerScopeLog.llgx

worked ! thanks bro

got it the idea i will try and go back to you

hi i have a problem with setup 2 rev limit with digital switch .. we try no enable gp input but not worked like we need G4+ Atom Sample.pclr

ok i will buy Owon VDS1022 but if there specisfic tool you prefer plz mention it !

Guys Give us some perfect tool i can use for scope signal I found this tool : https://www.amazon.com/Oscilloscope-Multimeter-LIUMY-Professional-Scopemeter/dp/B071F1H3PG/ref=zg_bs_393269011_1?_encoding=UTF8&psc=1&refRID=TV3MFSWJAZ3F6EF1JJKK

Any another idea ?

yes it's toyota trigger .. no misfire note: when i use ecu customer ( that was tuned by another tuner .. there no problem at this point ( extremely rich ) ) i try to increase arming threshold but same things ! ... maybe should be decrease 0 = 0.5 / 1000 = 1 / 2000 = 1.5 / 3000 = 2 / 4000 = 2.5 / 5000 = 3 / 6000 = 3 / 7000 = 3

I'm sure the problem is something else! not trigger ... check file plz

do you have a link for them ?

@Ducie54 how is work and what i need ? do you have link for tools or info about that

suzuki engine v6 .... 36 - 2 trigger ... waste spark ( atom ) also there another problem after drive car for 1 hour or less ... engine sound like 5 cylinder work only and lean on lambda ( 1.30 - 1.40 ) ... after wait 2 or 3 hour ... start very well !

also when i got this problem at same time i got trigger error log and file 2.llg old.pclr

hi i have a problem with our engine at wot 4000 - 4100 rpm ... Suddenly cutoff with backfire ! ... when i check datalog i found something wrong with injector duty cycle jump to 400% and rpm to 24801 ! note: - rpm limit set at 5500 - map limit OFF also timing drop to 3 deg

13.7 AFR for turbo engine ! Are you sure !

Please close the topic