wasted talent Posted November 26, 2019 Report Posted November 26, 2019 does anyone have a reasonable VE table and ignition table for a wrx v1/2 ej20g with id1000 they would be willing to share? by reasonable I mean starts and runs. having some difficulty getting the 2lt to start after switching out a blown 2.5 Quote
Adamw Posted November 26, 2019 Report Posted November 26, 2019 There is a WRX V1&2 base map in PC Link, although I wouldnt expect your 2.5 map to be that far away that it wont run. Have you changed trigger settings etc? Quote
wasted talent Posted November 26, 2019 Author Report Posted November 26, 2019 No settings were changed. Complete manifold inc coils was swapped over. Quote
Adamw Posted November 26, 2019 Report Posted November 26, 2019 So is the trigger mode set to Subaru V1-6 now? Can you attach a log of it cranking? Quote
JMP Posted November 26, 2019 Report Posted November 26, 2019 using the same crank sprocket and cam wheels? If not you'll likely have to check the triggers as Adam mentioned Quote
wasted talent Posted November 27, 2019 Author Report Posted November 27, 2019 i originally set up the tune on this engine before dropping in the 2.5 and retuning. trigger mode is v1-6 and filter is set to default of 1 2 logs attached. cranking.llg Trigger Scope Log 2019-11-26 5;32;23 pm.llg Quote
Adamw Posted November 27, 2019 Report Posted November 27, 2019 Your triggerscope shows nothing but your log looks ok. There is nothing obviously missing in the log. Have you checked there is spark and fuel? Can you attach the tune file also. Quote
wasted talent Posted November 27, 2019 Author Report Posted November 27, 2019 scope is blank or shows nothing obvious? this tune is the only one i have handy and did work but was very quickly compiled and rough EJ20g.pclr Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.