s14v8steven Posted January 3, 2020 Report Share Posted January 3, 2020 Hi new to this forum ! Just wondering has anyone wired a link atom to a 1uz non vvti as where in the middle of turbo charging the 1uz and want to run a atom ecu looking for a wiring diagram for a 1uz non vvti if any one can help out Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 4, 2020 Report Share Posted January 4, 2020 Most of what you need is in the help file I think. Is it a twin dizzy model? What specific bits do you need help with? Quote Link to comment Share on other sites More sharing options...
s14v8steven Posted January 4, 2020 Author Report Share Posted January 4, 2020 Thanks where do i find the help files i am new to this ? Ya it is a twin dizzy but im putting it on r8 coil now , just the 1uz engine sensor pin out really im after Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted January 4, 2020 Report Share Posted January 4, 2020 If you are going with the r8 coils, you would really be better off getting a Storm at minimum. You can make the r8 coils work with the atom but it will be configured as wasted spark and semi sequential fueling. Also with an atom on a turbo car, you are going to consume every bit of I/O and wish you had just ponied up for a larger ECU from the start. Quote Link to comment Share on other sites More sharing options...
Richard Hill Posted January 4, 2020 Report Share Posted January 4, 2020 One of our most popular kits is the Atom to run the 1uz cop, but usually normally aspirated. As mentioned above, the storm is a more capable ecu for that configuration, giving you sequential injection, sequential ignition, closed loop boost control and probably most importantly knock control. Quote Link to comment Share on other sites More sharing options...
s14v8steven Posted January 4, 2020 Author Report Share Posted January 4, 2020 I no what ya mean I bought the ecu and engine together so i said we try it out anyway and if we have to upgrade the ecu in the future we will ! Its for a drift car so only need the basics on it but I understand ye ahright , atom should run a turbo no bother aswell when it is tuned up ?? Quote Link to comment Share on other sites More sharing options...
s14v8steven Posted April 1, 2020 Author Report Share Posted April 1, 2020 just wondering where about i can find the base map for the 1uz to download if anyone knows thanks steven Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted April 1, 2020 Report Share Posted April 1, 2020 Theres a base 1uz calibration in the standard software download. Quote Link to comment Share on other sites More sharing options...
s14v8steven Posted April 10, 2020 Author Report Share Posted April 10, 2020 Thanks iv downloaded a base map change the spark to wasted spark , and the fuel to sequential injection and set the trigger filter to 2 and trigger mode 1uz fe non vvti , have the fuel around 3 bar , is there anything else i av to change in the ecu setting because it will fire up but will not wait runing , im runing a map sensor and air intake sensor aswel reading seem to be right , Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 10, 2020 Report Share Posted April 10, 2020 Sounds like you might need more fuel. Try increasing the master fuel number by about 50%. If that doesn’t help then attach your tune and log. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.