JohnRambo Posted March 19, 2020 Report Share Posted March 19, 2020 Hi I've looked in the pinouts and the Link doesn't have pin 44 for the neutral switch, but can it support it at all? i.e. stop idiots from not checking the car is in neutral before starting. Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 20, 2020 Report Share Posted March 20, 2020 If you have an old G4 then you are right, pin 44 is not connected. If you have a G4+ then it is connected to DI8. If you want to do something with the ignition switch then there are 2 spare digital inputs available on the expansion connector that you can connect the neutral switch to. Im still not sure what you are going to do with it however - the starter motor is not controlled by the ECU so even with a neutral switch connected the ECU cant do anything about someone cranking it in gear. You could do an ignition cut or similar to prevent it from starting but I dont know if thats what you want to achieve. You are probably better to wire the starter signal to a relay that is only energised when the neutral switch is closed. Quote Link to comment Share on other sites More sharing options...
Henryy Posted April 21, 2020 Report Share Posted April 21, 2020 Hello, I loan this thread for question concerning GTRLink pinout. Pin 44 was not mentioned in GTRLink G4+ pinout documentation but it was connected to DI8. How about DI7 and DI11 are these connected to ecu pins? Quote Link to comment Share on other sites More sharing options...
Simon Posted April 22, 2020 Report Share Posted April 22, 2020 Di7 is the Idle switch on pin 54, Di11 is not connected Quote Link to comment Share on other sites More sharing options...
Henryy Posted April 22, 2020 Report Share Posted April 22, 2020 Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.