mmmmm Posted April 26, 2020 Report Share Posted April 26, 2020 Hi Is it possible to to control a alternator with the v88? Need a rlo pwm signal 7,5hz 7v REGARDS Mickey Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 27, 2020 Report Share Posted April 27, 2020 10Hz minimum PWM frequency on the V88. It may work. Also, many of these types of alternators will also work fine without anything connected. Quote Link to comment Share on other sites More sharing options...
mmmmm Posted April 30, 2020 Author Report Share Posted April 30, 2020 It will only Make 13.5volts with out the signal. How do I set up the pwm? Cant find volts as a parameter. Would be nice to set a taget voltage Quote Link to comment Share on other sites More sharing options...
Simon Posted April 30, 2020 Report Share Posted April 30, 2020 You will put batt voltage as one of your axis's and can turn other of or might set up for engine speed or maybe load Then the table sets the pulse width of the PWM signal Quote Link to comment Share on other sites More sharing options...
Adzn3k Posted December 24, 2021 Report Share Posted December 24, 2021 just jumping on this thread to see if you got anywhere with it? my engine conversion can run a newer higher output unit but it needs an RLO wire added but need to workout whats needed Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.