Volcom86 Posted May 18, 2020 Report Share Posted May 18, 2020 Hi all, I have noticed these leans spots after I had my car tuned by a local tuner shop. As soon as I go increase % on the throttle the AFR's will go into a lean spot for 200ms or so https://www.dropbox.com/s/9dpqh3fwetd9y7f/cruise.llg?dl=0 (Log File) What is coursing these conditions - Is it the tip in enrichment? Is it something I should be concerned about ? Thank you in advance for your help Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 18, 2020 Report Share Posted May 18, 2020 In general I think it probably wants a bit more accel enrichment all over but if if drives ok without any flatspots or hesitation then i wouldnt worry about the general low load cruising stuff that your first pic shows.. The lean spike in your second pic at the 9:23 mark I would be more concerned about since it is at WOT and peak torque RPM so it is going to be pretty prone to knock around that area. Its hard to tell if it really is lean there or if it is something like a misfire that makes the probe read lean? On the short burst you gave it just prior to this one (~9:21) it didnt go anywhere near as lean. The main difference I can see from a fueling perspective was due to it being from lower RPM so got more accel enrichment. So you could try adding a bit more accel enrichment above 4000 to see if it has any influence. Generally you dont need much above 4000, but it depends on injectors etc. Volcom86 1 Quote Link to comment Share on other sites More sharing options...
Volcom86 Posted May 18, 2020 Author Report Share Posted May 18, 2020 22 minutes ago, Adamw said: In general I think it probably wants a bit more accel enrichment all over but if if drives ok without any flatspots or hesitation then i wouldnt worry about the general low load cruising stuff that your first pic shows.. The lean spike in your second pic at the 9:23 mark I would be more concerned about since it is at WOT and peak torque RPM so it is going to be pretty prone to knock around that area. Its hard to tell if it really is lean there or if it is something like a misfire that makes the probe read lean? On the short burst you gave it just prior to this one (~9:21) it didnt go anywhere near as lean. The main difference I can see from a fueling perspective was due to it being from lower RPM so got more accel enrichment. So you could try adding a bit more accel enrichment above 4000 to see if it has any influence. Generally you dont need much above 4000, but it depends on injectors etc. Thanks for the Input again Adamw... I forgot to ask if the lean spike in the log could possibly be coursed by CLL rate down settings impacting this? Thanks again for your feedback I really appreciate it. Cheers, Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 18, 2020 Report Share Posted May 18, 2020 No it doesnt appear to be CLL related. Quote Link to comment Share on other sites More sharing options...
Volcom86 Posted June 7, 2020 Author Report Share Posted June 7, 2020 Hey Adam, Hope all is well. I finally got to go do some testing. I changed added some Accel Enrichment above 4,000RPM am I perhaps not giving it enough? Attached log file. https://www.dropbox.com/s/s8x6r4v3upesly2/test 7.6.2020.llg?dl=0 Injectors are 1,700 ID's 04 MY05 STi with standard drive by cable throttle body I should also mention that my AFR sensor is in the middle part of the exhaust past the dumpipe section where it meets the middle section Thank you for any feedback Quote Link to comment Share on other sites More sharing options...
remski2 Posted June 7, 2020 Report Share Posted June 7, 2020 Hi. Your Right AVCS seems to be off target by quite a bit. Could that be causing the AFR discrepancy ? Quote Link to comment Share on other sites More sharing options...
Volcom86 Posted June 8, 2020 Author Report Share Posted June 8, 2020 Yes, indeed thank you pointing that out it looks like the solenoid is lazy. I will swap them around and see if bank 2 will repeat the problem Thanks, Quote Link to comment Share on other sites More sharing options...
Volcom86 Posted June 9, 2020 Author Report Share Posted June 9, 2020 I have taken the solenoids out gave them a good clean ans swapped them around and success. Back where they are in sync. Thanks for pointing that out remski2 Still seeing the random lean spike. I don't understand it Quote Link to comment Share on other sites More sharing options...
remski2 Posted June 9, 2020 Report Share Posted June 9, 2020 Exhaust / wideband leak ? Quote Link to comment Share on other sites More sharing options...
Volcom86 Posted June 10, 2020 Author Report Share Posted June 10, 2020 11 hours ago, remski2 said: Exhaust / wideband leak ? Could it be because the AFR sensor is so far away in the mid section of the exhaust? So it a delay factor and not a actual lean spike Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.