hung_lo Posted July 17, 2020 Report Share Posted July 17, 2020 I just had my injectors cleaned and flow tested, and was wondering what would be the most efficient way to compensate for the variance in flow. Would it be using the “Individual Cyl Fuel Trim Table”? I was thinking of using the “Single” mode, and assuming that I put the injectors in the order of the printout: -3.12% 3.96% -5.09% 5.02% *based on the average static flow # of 512.50cc/min does this sound correct? Quote Link to comment Share on other sites More sharing options...
neil brown Posted July 17, 2020 Report Share Posted July 17, 2020 Turbo charged car ? if change fuel trim for each injector how do you know if it’s richer on that cylinder individual lambdas on each exhaust port Quote Link to comment Share on other sites More sharing options...
hung_lo Posted July 17, 2020 Author Report Share Posted July 17, 2020 12 minutes ago, neil brown said: Turbo charged car ? if change fuel trim for each injector how do you know if it’s richer on that cylinder individual lambdas on each exhaust port I’ve included the flow test on the injectors. there is quite a large variance between the injectors that i’d like to compensate for Quote Link to comment Share on other sites More sharing options...
neil brown Posted July 17, 2020 Report Share Posted July 17, 2020 There is a 10% difference between injectors one the flow for me I would not be happy using them, would try to get other injectors and get the 4 close matching injectors Quote Link to comment Share on other sites More sharing options...
hung_lo Posted July 17, 2020 Author Report Share Posted July 17, 2020 I agree, I will be changing the injectors down the road when it gets a retune. I’d like to compensate for the flow variance for now. Quote Link to comment Share on other sites More sharing options...
neil brown Posted July 17, 2020 Report Share Posted July 17, 2020 Can you measure each cylinder for afm if not it’s a guessing game Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 17, 2020 Report Share Posted July 17, 2020 Yes, single mode with your proposed corrections would work. To be honest they are pretty typical for those injectors I wouldnt be too concerned. Quote Link to comment Share on other sites More sharing options...
Electredge Posted July 18, 2020 Report Share Posted July 18, 2020 I recently did an EVO 9 using and AEM 4 channel wideband and logged each cylinders AFR.... the unit isn't too expensive and with a Link I'm sure you could even send the CAN data into it and log directly to the ecu. granted adding 4 bungs to a header/manifold might be a bit on the pricey side but it was good learning experience. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.