Colinmcraika Posted September 24, 2020 Report Share Posted September 24, 2020 Hi team Just a quick question regarding my new sequential gear box setup. Im running link g4+ fury i have an albins st6 and the hollinger shift cut knob, so will be setting up closed loop shift cut etc and running the gear display on my dash, so anyway as this box has no reverse switch can i configure a low side output to operate a relay in reverse to run my reverse lights? Quote Link to comment Share on other sites More sharing options...
dx4picco Posted September 24, 2020 Report Share Posted September 24, 2020 I guess if it is a barel type sensor you could simply make an GP aux output with condition on the voltage from that sensor coresponding at the reverse position. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 24, 2020 Report Share Posted September 24, 2020 As above you can use a GP output using either a voltage window, or as below use gear >9, <11 (reverse is gearĀ 10). Quote Link to comment Share on other sites More sharing options...
Colinmcraika Posted September 25, 2020 Author Report Share Posted September 25, 2020 Awsome thanks for the reply, will have a go at it in a couple weeks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.