Helical Posted February 21, 2021 Report Share Posted February 21, 2021 I followed the instructions for the bti gauge and I get a “No processor “ error at the bottom. I have loaded the file to the ecu can setting and stored it. It is plugged into Can1 on the ECU board. Did I do something stupidly obviously incorrect? I have used the antenna as a 12v source since I do not use the radio. It shows 12v when the key is switched on. Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 21, 2021 Report Share Posted February 21, 2021 I suspect this will have to be a question for BTI, the error is not very descriptive but it suggest something may be wrong at the dash end. In the ECU, have have you loaded their LCS template and set up the "transmit user stream" etc? Quote Link to comment Share on other sites More sharing options...
Helical Posted February 21, 2021 Author Report Share Posted February 21, 2021 2 minutes ago, Adamw said: I suspect this will have to be a question for BTI, the error is not very descriptive but it suggest something may be wrong at the dash end. In the ECU, have have you loaded their LCS template and set up the "transmit user stream" etc? I have. It’s on stream channel 1 and loaded the LCS file in the stream tab. Quote Link to comment Share on other sites More sharing options...
Helical Posted February 21, 2021 Author Report Share Posted February 21, 2021 46 minutes ago, Adamw said: I suspect this will have to be a question for BTI, the error is not very descriptive but it suggest something may be wrong at the dash end. In the ECU, have have you loaded their LCS template and set up the "transmit user stream" etc? I have. It’s on stream channel 1 and loaded the LCS file in the stream tab. i am also getting fault code 17 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.