Quino Posted March 7, 2021 Report Share Posted March 7, 2021 Hi, I bought an extra CAN Lambda sensor and I would like to set it up to have 2 CAN Lambda modules while running. I followed the steps that the help section indicates, but the ECU doesn't seem to find the new module. I checked if the CAN Bus, Ground and Supply are alright and there is no problem there. Does anyone know why this is going on?? Quote Link to comment Share on other sites More sharing options...
Confused Posted March 7, 2021 Report Share Posted March 7, 2021 You need to disconnect the first, and only have the 2nd connected. You can then go into the CANBUS setup, and modify this to be Lambda 2. Then you can plug the first back in. Out of the box, they are all set up for use singularly, as Lambda 1. Adamw 1 Quote Link to comment Share on other sites More sharing options...
Quino Posted March 9, 2021 Author Report Share Posted March 9, 2021 On 3/7/2021 at 6:13 PM, Confused said: You need to disconnect the first, and only have the 2nd connected. You can then go into the CANBUS setup, and modify this to be Lambda 2. Then you can plug the first back in. Out of the box, they are all set up for use singularly, as Lambda 1. Many thanks, I think my problem was that maybe I didn't unplug the first Lambda that I configured. I'll try it today! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.