Mr_Flibble Posted April 11, 2021 Report Share Posted April 11, 2021 So Got the engine running without getting the cat to glow red hot. But if I press the accelerator gently the engine seems to bog down, if I pump it the RPM will climb, What could cause this ? The timing seems to be correct for the car. And if I increase the fuel the engine floods and won't start. Knocking seems a bit excessive as well. today.llg sol-9.pclr Quote Link to comment Share on other sites More sharing options...
remski2 Posted April 11, 2021 Report Share Posted April 11, 2021 I'd check the TPS as its fluctuating quite a bit. Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 11, 2021 Report Share Posted April 11, 2021 Knock control and closed loop lambda should be turned off until after it is tuned. Cant help with much else with no lambda connected. It sounds like you need to get a tuner involved now. Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted April 12, 2021 Author Report Share Posted April 12, 2021 Tps fluctuating is me pumping the throttle. The biggest issue is the only place that can tune it is an hour away and I need to get an mot and drive it there. Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted April 14, 2021 Author Report Share Posted April 14, 2021 Log 2021-04-14 6;54;34 pm.llgThere is still something very wrong it seems to tick over but just slowly dies, I have to work the throttle to keep it going it coughs and backfires. The timing just seems off but timing gun says no I have just found out by looking at the timing whilst tweaking throttle, the ignition retards when I open the throttle meaning the engine dies This is not normal behavior, I thought it advances a little. Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted April 14, 2021 Author Report Share Posted April 14, 2021 When I say the ignition retards I mean it goes to the level that I first set it to during the calibrate. Quote Link to comment Share on other sites More sharing options...
Mr_Flibble Posted April 14, 2021 Author Report Share Posted April 14, 2021 sol-10.pclr latest config Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 14, 2021 Report Share Posted April 14, 2021 Your log shows the correct ignition timing being commanded. Your engine makes no vacuum. This would suggest a massive leak or the cam timing is very wrong - has the engine been apart? Is the MAP sensor definately a Link 3 bar sensor? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.