unex Posted July 14, 2021 Report Share Posted July 14, 2021 Hi guys, turbo speed question once again. I was almost happy after FW update, but... As help file says: calibration number=6000 x number of teeth (number of compressor blades) / Divider. Lets take Borgwarner EFR turbo with 14 blades and borgwarner speed sensor with 8 divider. So calibration number should be 6000 x 14 / 8 = 10500, right? But software is limited to 10 000. Is there any reason for that? If I will use 1050 calibration instead of 10500 I will get correct number except missing one zero? For example instead of 50krpm i will see 5krpm? EDIT: calculated answer to my second question, and actually I will see one zero too much. For example, instead of 50krpm I would see 500krpm. BTW, its G4+ Thunder. Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 14, 2021 Report Share Posted July 14, 2021 Im not sure if there is any major limitation that prevents us from allowing a cal number larger than 10000. I will put in a request for the firmware guys to have a look at it when they are next working on G4+. Quote Link to comment Share on other sites More sharing options...
Yvo Posted July 18, 2021 Report Share Posted July 18, 2021 Following, i have the same issue Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.