Sensor ground and shield ground for Link Fury G4X

[Edmund Turner]

HI gents, I need to confirm my understanding of the sensor ground/gournd out and shield grounds for a Link Fury G4X.

As I understand the shield ground pins (A7) are also connected to Sensor ground pins (A25). When wiring crank and cam position sensors, can I combined the shield wires with the sensor ground for the crank/cam sensors and connect them to shield ground A7? 

 

 

As for knock sensors; can I do the same to combine the knock sensor ground and shield wires to B17?

 

thanks in advance.

[Adamw]

Yes, that is the intent.  In our Link looms the trigger sensor grounds and shields are all spliced together and connected to pin A7.  On the B loom, both knock grounds and shields are spliced together and connected to B17.

[Edmund Turner]

Thanks for this mate.

[mapper]

 

On 10/19/2021 at 9:46 PM, Adamw said:

Yes, that is the intent.  In our Link looms the trigger sensor grounds and shields are all spliced together and connected to pin A7.  On the B loom, both knock grounds and shields are spliced together and connected to B17.

Just to confirm if this is correct?

Gnd Out = Sensor Ground 

Gnd Out is internally connected to Gnd/Shield right? 

So I can also connect any other sensor ground to Gnd/shield? 

[Adamw]

Correct, Gnd Out and Gnd/Shield pins are sensor ground/0V.