randolph Posted November 24, 2021 Report Share Posted November 24, 2021 Adam,could you help me out with this,i'm in the process installing a link can lambda and a newly released gauge display onto a g4+ extreme ecu, since i've already done it on g4x successfully, i thought it was going to be straight forward, i'm not seeing (link can) in the calibration selection. could you give me a brief explanation of how it;s done with the g4+ ecu as there's not much in the help file either, thanks Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 24, 2021 Report Share Posted November 24, 2021 All you need to do is set up the CAN like below, and make sure you have no analog inputs assigned to Lambda 1. Quote Link to comment Share on other sites More sharing options...
randolph Posted November 25, 2021 Author Report Share Posted November 25, 2021 Ok, so same as g4x can set up, except for analogue being off. Thanks Adam Quote Link to comment Share on other sites More sharing options...
INSW20 Posted November 25, 2021 Report Share Posted November 25, 2021 I didn’t see any CAN pins or expansions for my TST185+, correct? Or did I miss them somewhere? EDIT: looking at my board I see the expansion connector for it, would it just use the same CAN expansion as the rest? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.