[email protected] Posted January 21, 2022 Report Share Posted January 21, 2022 I have installed a new oil pressure sensor. It reads on average 460kpa when driving. When I stop the motor and moments later the manual orange light on the dash of the car comes on the link is reporting the oil pressure at 60kpa. What I want is to have the ecu programmed in the engine protection area to cut ignition if the oil pressure drops below 60kpa when driving. Can you help me program this in? Can we have it so there is a delay. I.e when it is cranking it would be nice to have spark before it reaches 60kpa. Here is a google drive link with my tune file and a current log file: https://drive.google.com/drive/folders/1s7HLvk_nMzjlg0HG2_RvO8hxJ6RzYmV9?usp=sharing The car runs a dry sump pump and tank. It idles at about 300kpa and drives at about 450kpa. The engine is a 3sge beams with itb throttles. The ecu is a Link g4+blue storm. Thanks for your help. Rex Quote Link to comment Share on other sites More sharing options...
essb00 Posted January 21, 2022 Report Share Posted January 21, 2022 Make a GP RPM Limit looking like this (just modify accordingly)... Gsab 1 Quote Link to comment Share on other sites More sharing options...
[email protected] Posted January 21, 2022 Author Report Share Posted January 21, 2022 I am still a little suck. I have made a GP Rpm Limit but it looks different to your picture. Here is a google drive link with a picture and my tune file in it. https://drive.google.com/drive/folders/1RuXipkSxHfjgSnDWOfyFMLllImdN3Zc8?usp=sharing Questions: Why when I go to axis setup on the top of the table can i only see: engine speed. Your picture on the top of the axis says GP RPM Limit. Is this because yours picture is from a g4x and mine is a g4+? Or have a programed somehing wrong? Thanks for your help. Kind Regards Rex. Quote Link to comment Share on other sites More sharing options...
essb00 Posted January 21, 2022 Report Share Posted January 21, 2022 That is same in G4+ and G4X. I did that one on G4+ Pclink... You can set the X axis parameter to 'none'. ...I can't seem to access your shared link. [email protected] 1 Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 21, 2022 Report Share Posted January 21, 2022 There is an oil pressure GP limit example and explanation in the help file. You can find this by clicking on GP RPM limit 1 and hitting F1. I will attach below anyhow. Gsab and [email protected] 1 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.