wastegate Posted January 23, 2022 Report Share Posted January 23, 2022 Hi Guys, Hopefully can give me some insight into what I'm missing here. Have a IC7 connected to my G4X. My gearbox is sending gear selector info via CAN to a translator I coded. The Arduino is then retransmitting gear selector onto CAN ID 1500 on frame 1 byte 0 to suit Range = 0 - 8,P,R,N,D,H,L in hex, 0x00-08,09,0A etc decimal 0->14. PCLink is showing the correct selector just fine. Gear is showing P when in Park R in Reverse etc.. However the IC7 is only showing the decimal number on the gear. So P is showing 9. Looking at the Generic Dash CAN setup, looks like it should be right. Does the IC7 support shifter position via Gear? This something I should take up with Haltech? Nick-gear-pclink-logs.zip Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 23, 2022 Report Share Posted January 23, 2022 Sounds like a question for Haltech if they dont support all of the enumerations. We could possibly try duplicating one of the other supported ECU streams if you get no joy from them. Not sure if any of the others support PNDR? Quote Link to comment Share on other sites More sharing options...
wastegate Posted January 23, 2022 Author Report Share Posted January 23, 2022 Thanks Adam, will hit them up. Quote Link to comment Share on other sites More sharing options...
wastegate Posted January 25, 2022 Author Report Share Posted January 25, 2022 Just a small update, Haltech have added in the new enumeration for the gear position on the G4X Generic Dash stream, and will make the change in the next firmware update. So all working now. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.