Launch Control + Pit lane limiter

[Walker motorsport]

Hi there,

For my race only car:

I already have a launch control setup which works great using clutch switch DI, but i also want to have another DI to use for pit lane speed limiter. is this possible?

I dont have any form of speed trigger / sensor, i.e. i only have RPM and Gear so from what i can see i cant use any speed limit options?

Any help will be appreciated 

Thanks
Andrew

[Vaughan]

Could use a GP RPM Limit with the switch on one axis and pick an RPM that matches speed for the gear that you will be in.

[Walker motorsport]

Thanks Vaughan ill give that a go.

[Adamw]

I think something like below would do it.  

I have a virtual aux set up to activate launch control when the clutch switch OR the Pit switch is active.

In the 3D launch table I have the Pit switch on the Y axis so it will use the top row of the table for launch control or the bottom row for pit limiter.  Then you can put gear on the X axis if you want to factor gear into the pit limit.  

 

[DerekAE86]

Slightly related - is there a way to toggle and latch limit tables between power cycles in software?

Without the need for a physical toggle switch that will keep an input high or low.