Gtr_lee Posted February 10 Report Share Posted February 10 Tried to set up my aem wideband via can today but can’t seem to get it to work. have set it up as per the images after searching the forum but still no luck. has the 120ohm terminating resistor installed in the dtm plug and wired in to can 1 on the ecu. i get the green light on the aem unit to say it has power but nothing else. Quote Link to comment Share on other sites More sharing options...
essb00 Posted February 10 Report Share Posted February 10 Instead of 'Mode'>"Receive User Stream 1", you need to select there "Link CAN-Lambda". Quote Link to comment Share on other sites More sharing options...
Gtr_lee Posted February 10 Author Report Share Posted February 10 I did see that in the drop down menu but read in the help file that it wants you to select stream x and not link can-lambda Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 10 Report Share Posted February 10 The CAN set up looks correct. Make sure in the analog input menu, Lambda 1 sensor control is set to "Link CAN" Quote Link to comment Share on other sites More sharing options...
Gtr_lee Posted February 10 Author Report Share Posted February 10 Yes, it is set to Link CAN. I double checked this while i had the car idling but still had no reading Quote Link to comment Share on other sites More sharing options...
Vaughan Posted February 11 Report Share Posted February 11 Is the gauge set to be Lambda ID 1, is it wired to CAN 1, plugin or wire in ECU? Also if you go to the runtime View and across to the CAN tab do you see any errors showing up in the CAN 1 statuses? Quote Link to comment Share on other sites More sharing options...
Gtr_lee Posted February 12 Author Report Share Posted February 12 Hi Vaughan, I went to have a look at the connection at the ecu and can Lo had somehow snapped from the terminal in the jst plug! This is most likely the issue but cannot confirm until I get some new terminals delivered to test. But yes it was set to Lambda 1 and was wired to Can 1 in the nb2x plug in ecu. Once I have redone all the wiring I will see what happens in the runtime view if it still is not reading correctly I appreciate the help Vaughan 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.