Alexi81 Posted June 20 Report Share Posted June 20 Hello everyone, I am facing a problem with the CAN LAMBDA module. I have spent two evenings reading various posts on your forum, but I can’t find an answer!!! I am following the procedures from the CAN Lambda documentation with the ID 950, but I am unable to get the Lambda values in the software. Here are my files: If you have any ideas, thank you. Alexis seb.pclr Log 2024-06-18 3;00;52 pm.llg Quote Link to comment Share on other sites More sharing options...
Vaughan Posted June 20 Report Share Posted June 20 setup looks correct and I can't see any issues on the CAN bus, can you find the Link CAN Lambda in the CAN Devices tab of the CAN Setup window? have you checked if you have power and ground to the CAN Lambda with a multimeter? Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 20 Report Share Posted June 20 This looks like an Altezza ECU isnt it? There is no CAN 2 port on the Altezza ecu, this bus is used for the BEAN communication. The CAN lambda should be set up on CAN1. Quote Link to comment Share on other sites More sharing options...
Alexi81 Posted June 26 Author Report Share Posted June 26 hello Adamw, Thank you for your response. Indeed, I need to connect to the CAN1 port. Can you tell me what type of connector I should use? Is it a JST or XAP connector? Thank you for your answer. Would you like me to provide any information about CAN connectors or help you determine which type you need? Alexis Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 26 Report Share Posted June 26 The CAN connector is a JST XA series. Quote Link to comment Share on other sites More sharing options...
Alexi81 Posted June 27 Author Report Share Posted June 27 Thank you Adamw. Alexis Quote Link to comment Share on other sites More sharing options...
Alexi81 Posted July 1 Author Report Share Posted July 1 Hello, Finally I have a response from the CAN LAMBDA module. Now I'm wondering how to configure it to visualize the Lambda values. Do I need to associate an Analog input with Lambda 1? Thank you for your help. Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 2 Report Share Posted July 2 You dont need to associate anything. Do you have a gauge or runtime display set up to show Lambda 1? There is a Lambda gauge on the tuning tab of the default layout. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.