Alan Mullins Posted February 12, 2011 Report Share Posted February 12, 2011 The white wire in the adapter loom has been cut, Can you tell me what it is for? Just bought this off trade me. A G1 with D42V4a on it, Is that a V4 model? Thanks, Alan. Quote Link to comment Share on other sites More sharing options...
Simon Posted February 14, 2011 Report Share Posted February 14, 2011 It is a V4 firmware. The white wire is usually the Oxy sensor input. It would pay to check this by pin location on the header. The pin out is in the V4 manual that can be downloaded from http://www.linkecu.com/support/documentation/g1-engine-management-documentation/lemv4manual Quote Link to comment Share on other sites More sharing options...
Alan Mullins Posted February 14, 2011 Author Report Share Posted February 14, 2011 OK, it looks like o2 sensor, I will need that hooked up wont i? Thanks. Alan. Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted February 15, 2011 Report Share Posted February 15, 2011 Hi Alan. It's not really going to help you a lot because this is a narrow band input only. Don't bother with buying one to install if you don't have one already. They are expensive, and practically useless. Jurgen Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.