G4 with DisplayLink!

[Dadoulis Paschalis]

Hi all!!

Is Displaylink compatible with G4 also?? I'm reading in the Displaylink page that it is, so shall I connect it?? Will it work?

Thanks!

[Scott]

Hi Dadoulis,

Yes the DisplayLink is compatible with G4 ECUs. It will work over serial with all models that have the serial/CAN connector. For it to work over CAN the ECU needs a serial number of greater than 10,000 and the DisplayLink needs to be on later firmware.

You can find the DisplayLink documentation here

http://www.linkecu.com/support/documentation/displaylink-documentation' target='_self' title=''>

Cheers

Scott

[Scott]

Hi again,

You have a couple of options.

1. Connect your DisplayLink to the CAN/Serial port of your ECU and set the DisplayLink up to use serial communication. This will work for you with no hardware changes.

OR

2. Send your ECU and DisplayLink to us and we will perform the CAN upgrade on your ECU and also update the firmware on your DisplayLink. The cost to you would just be shipping. If you are interested in this please email [email protected]

The firmware upgrade on your DisplayLink can not be done in the field, it must be returned to us.

Scott

[Scott]

Which G4 ECU do you have?

On the RX, Storm and Xtreme there are two ports, the top one is the tuning port, the bottom one is the CAN/Serial port.

Scott.

[Simon]

Hi As the ECU is below Serial 10000 we will need to get it back.

The ECU will have a hardware change to allow CAN coms.

The Display if of similar age will also need an up grade if you can not select Link U Can in the ECU type under Display setup.