Harry Clark Posted October 2, 2014 Report Posted October 2, 2014 Sorry if already covered have searched through forum. Â I am wanting to setup speed for my G3 with a 3 pin sensor in a toyota. If i setup as per drawing S-08 what is the setup required in the link? Â I am using a display link so want to setup to use on there. Thanks in advance, Harry Quote
Simon Posted October 3, 2014 Report Posted October 3, 2014 You will need a free digital in put to wire to. (note the LEM only has one digital input) You will need to set the DI to speed and then calibrate so speed reads correctly. Â Quote
Harry Clark Posted October 3, 2014 Author Report Posted October 3, 2014 So it does need the earth and 5v in? Â Take as sensor ground and +5v from ecu? Â DI was not used so will be fine. Â Also I am going to get the firmware updated to G4 is there a tune that is setup for G3 to start from seing there are different inputs and outputs compared to any of the g4 stuff? Quote
Scott Posted October 6, 2014 Report Posted October 6, 2014 Hi Harry, Yes, the sensor will require the +5V and sensor ground from the ECU. For a G3 being upgraded to a G4 there is no starting base-map. As part of the process you do a 'Restore to factory Settings', which effectively sets the ECU to a blank base-map. You can find a document detailing the process here: http://www.linkecu.com/support/documentation/g4-engine-management-documentation/g3-to-g4-upgrade  Scott Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.