Lyndon Sharp Posted April 18, 2016 Report Share Posted April 18, 2016 I can't seem to get the heater to heat. It just bomb out with a Heater took to long Error. I double checked the wiring and continuity tested it. Tried 2 Fury's and both error after a calibration period.. One did get to about 15 degrees and stop the other did nothing. IS there a hidden turn on heater option I'm missing? The second plug has power and both grounds connected and checked.I also checked 2 sensors, both did the same.Lyndon. Quote Link to comment Share on other sites More sharing options...
Simon Posted April 18, 2016 Report Share Posted April 18, 2016 Check the power supply to the sensor is good enough to supply the required current.It could be the power supply is dropping out. You could check the voltage to the probe when the heater is trying to run. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.