Interpolate between boost tables

[PitBull]

I want to interpolate between two boost tables.  The help file states:

"When set to Interpolate Between the Boost Table Ratio Table appears. The Boost Table Ratio Table is used to control the interpolation between Wastegate % DC Table 1 and Wastegate % DC Table 2."

Does it also interpolate between the Boost Target tables 1 and 2?  It seems like that would be the desired effect (and is what I'm looking for) but the help file doesn't state that explicitly so I wanted to be sure.

Thanks

PB

[CamB]

I hope so - it's what I plan to do. When I look at the help file it looks like it does:

When set to Interpolate Between the Boost Table Ratio Table appears. The Boost Table Ratio Table is
used to control the interpolation between Wastegate % DC Table 1 (and Boost Target Table 1) and
Wastegate % DC Table 2 (and Boost Target Table 2). The x (horizontal) axis of the Boost Table Ratio
Table is configurable. Commonly used parameters include %Ethanol, Multi Fuel Blend Ratio, or an An
Volt channel.

[Scott]

When on Closed Loop boost control mode the Boost table ratio table will interpolate between the two wastegate DC% tables and the two boost target tables.

Scott

[Brad Burnett]

Even when I set up dual boost tables that do not interpolate between each other, I always have the wastegate tables the same and the only difference is the target tables.

[PitBull]

Odd...my help file reads slightly differently than yours CamB.

Brad, yes my WG DC tables are identical too, which is why I was hoping this feature interpolates between the target tables.  I have RPM on my X axis and boost target on Y.