Tunedgether Posted August 22, 2017 Report Share Posted August 22, 2017 Dear Technical Support,I installing Link Thunder to BMW S65 engine but I have problem about DBW system. I would like to know how to setup The Link Thunder control throttle actuator of this engine.Regard, Quote Link to comment Share on other sites More sharing options...
Brad Burnett Posted August 22, 2017 Report Share Posted August 22, 2017 Best place to start is reading the E Throttle section of the help file. Quote Link to comment Share on other sites More sharing options...
Tunedgether Posted August 23, 2017 Author Report Share Posted August 23, 2017 (edited) Thanks for reply. But this throttle autuator not same normal E-throttle. It have 9wires connect to throttle autuator and 6wires connect to TPS sensor. I don't understand E-throttle this type. Please halp.Regards, Edited August 23, 2017 by Tunedgether Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 23, 2017 Report Share Posted August 23, 2017 The little info I have found on this engine is the actuators are controlled over CAN bus. I vaguely remember seeing mention somewhere that they can be modified to bypass the CAN and get a direct connection to the motor but you will have to either research that yourself or open one up. We dont currently have all the functionality in the Link software/firmware to control these actuators properly over CAN. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.