mjb214 Posted April 16, 2018 Report Share Posted April 16, 2018 I am looking for some guidance. I am putting a 2GR-FE in a MR2 and turbo'ing it. I have the Link G4+ Fury. I am starting to lay out the wires but am wondering the best way to combine the power for things like the Coils and Injectors. The same for a lot of grounds. Is it common to run power to INJ 1 then jump it to the next one and so on. For reference I have labeled the cylinders by their firing order which is with the cam gear on the right, back left is Cyl 1 Front left is Cyl 2 back middle is 3 and so on. I believe firing order is 1,2,3,4,5,6 with the labeling as I mentioned. Same question for the 5V items like sensors and DBW TB. Thanks for the help. Quote Link to comment Share on other sites More sharing options...
ClintBHP Posted April 16, 2018 Report Share Posted April 16, 2018 For the injector +14v line I take them back into the loom and use a glued heat shrink tyco splice to pull them back to the relay. 5v are fine to splice the same way. the grounds must be run separate to the grounding point on the engine. Quote Link to comment Share on other sites More sharing options...
CDNMR2V6 Posted April 17, 2018 Report Share Posted April 17, 2018 The original engine harness has the injectors powered in parallel. Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 17, 2018 Report Share Posted April 17, 2018 I pinched this pic off HP Academy's forum but you would typically splice your 5v, sensor ground & injector supplies similar to below. Quote Link to comment Share on other sites More sharing options...
mjb214 Posted April 19, 2018 Author Report Share Posted April 19, 2018 Thanks for the feedback. Anyone have pointers for a base map or tips for 2gr with a turbo? I am still a few weeks from turning the key for the first time then have to make the exhaust and intake piping. Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 20, 2018 Report Share Posted April 20, 2018 Start with the Fury sample map then configure all inputs/outputs to match your wiring and sensors etc. Then post it here and we will take a quick look over. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.