skeruno Posted November 7, 2018 Report Share Posted November 7, 2018 Hi there! Is there a way to feed 2 wideband signals into the 350ZLINK? Currently i use the expansion loom for 1 5 volt input (AN volt 8). But i see on the wideband controller(Innovate DLG-1) that the banks differ a lot. I see the software on the ecu supports it but i see no other 5 volt input. You guy's have any idea? Kind regards, Vincent Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 8, 2018 Report Share Posted November 8, 2018 You can repurpose a couple of inputs on the main header. Here's a few that probably arent being used: AN Volt 3, Pin 51, was originally for the MAF AN Volt 10, Pin 35, was originally for the RF narrowband oxy. AN Volt 11, Pin 16, was originally for the LF narrowband oxy. Quote Link to comment Share on other sites More sharing options...
skeruno Posted November 12, 2018 Author Report Share Posted November 12, 2018 Thank you! I will rewire the maf one and use that. Vincent Quote Link to comment Share on other sites More sharing options...
AbbeyMS Posted November 12, 2018 Report Share Posted November 12, 2018 Just use 2 x Link can lambda's set up send everything down Can 2. Quote Link to comment Share on other sites More sharing options...
skeruno Posted November 13, 2018 Author Report Share Posted November 13, 2018 Yes i was thinking about that but with just 1 rewire i will achieve the same result without any purchase. If the rewire does not does the trick i will go the CAN way. Thanks for your reply! Kind regards, Vincent Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.