Honda with COP and AEM epm

[3rdgenls1]

Hello, 

I need some help before i try to restart my car tomorrow. 

My setup is a honda 1.6 dohc zc converted to COP with AEM epm. I need some help with the trigger setup, most i found on here but these below i dont know what they should be, would these be correct. 

Trigger setup

Trigger mode: multi-tooth

Trigger priority: trig 1

Trigger 1

trigger 1 edge : falling

Multi tooth position: crank 

Tooth count: 24

Trigger 2

trigger 2 edge: falling

Syn mode: cam pulse 1x

 

Also only cylinder number 1 coil got warm the rest 2,3,4 were cold, is this a trigger issue or wiring issue. 

Any help would be great

 

 

[Adamw]

trig 1 multitooth position should be set to cam.

 

22 minutes ago, 3rdgenls1 said:

Also only cylinder number 1 coil got warm the rest 2,3,4 were cold, is this a trigger issue or wiring issue. 

If you use the ignition test function do all coils spark?  Do you have ignition mode set to direct spark?

[3rdgenls1]

I do have ignition set to direct spark, when i start to work on it tomorrow again im going to redo my coil grounds and then do the ignition test function. 

Ill let you know how that goes, also thanks for the quick reply and help. 

[3rdgenls1]

Thanks for the help the car is running and at my tuner as i write this.