Confused Posted December 21, 2018 Report Share Posted December 21, 2018 Hi, I have Cruise Control generally up and running OK, but would like to switch E-Throttle target table when Cruise is active to try to further smooth out the throttle response (a suggestion I saw in another thread on here). I'm trying to set up an output as "Cruise Active", but it never switches to "On" state - have tried Virtual Aux, as a generic Aux and an Ignition Aux, but all with the same result - Cruise Active doesn't seem to change to Active. I'm running 5.6.6.3557, and other than this, haven't come across any other issues, so would prefer to not roll back if possible! Any advice or things to try will be appreciated (although may be a little slow in trying out suggestions due to the Christmas period) Cheers! Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 21, 2018 Report Share Posted December 21, 2018 I assume you are using the "cruise light" output? Unfortunately, this doesnt work at present, it was reported a few months back and is on the list of things to fix at the moment. Quote Link to comment Share on other sites More sharing options...
Confused Posted December 22, 2018 Author Report Share Posted December 22, 2018 Hi Adam, Yep, it's "Cruise Light" I've been trying to use. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.