Jump to content

Lambda signal

Ronny Beeler

Recommended Posts

  • 4 weeks later...

Youll need to wire the 0-5v output from your wideband into pin 13 of your ECU (AN Volt 3) which is currently setup for NB Oxy and then got to AN Volt 3 under analougue inputs and change the function from "NB Oxy" to "Lambda 1" and then choose the calibration from the presets or input the calibration details from you your wideband controller.

or you could use the AEM X-series UEGO that has CANBUS capability and wire it into your ECU over CAN and the link software already has this device setup as a preset stream.


the pin location etc is all in the attached manual for your ECU from page 17 onwards.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...