neil brown
-
Posts
372 -
Joined
-
Last visited
-
Days Won
3
Content Type
Profiles
Forums
Events
Gallery
Blogs
Posts posted by neil brown
-
-
Current set is classic gc8 which uses 6/7 timing gears
can the current link wrx5/6 ecu run a newage set up as its currently set up for pin out for a classic
-
Classic timing wheels 92-99 Have different teeth set up think it’s a 6/7 set up
newage timing wheels 20000-2006 have 36-2-2-2 teeth set up to suit cam shaft wheel and Avcs set up
-
To run avcs you will need to fit newage timing wheel to crank to suit camshaft timing wheel And set the ecu for newage timing config
then move some pins around as camshaft sensors need to be on di 1 and 2
-
Can you measure each cylinder for afm
if not it’s a guessing game
-
There is a 10% difference between injectors one the flow
for me I would not be happy using them, would try to get other injectors and get the 4 close matching injectors
-
Turbo charged car ?
if change fuel trim for each injector how do you know if it’s richer on that cylinder
individual lambdas on each exhaust port
-
Fair enough
My car did have air con but used space for other stuff
both my fans come on at same time to cool engine
seems to be work fine
always been like that even when I was on a G1 link ecu
-
I just run 1 output for my both my fans
will post set up later
-
Is the can mod easy to ? Or do I need to send it in
-
That’s the data cable from the storm ecu which goes to female socket of link display
when that is unplugged no data on screen
-
Socket is the data plug of the link display
-
Also the plug in ecu has serial number under 10000
is there a can mod to allow pc and link display to be connected at same time like the g4 storm wire in ecu (silver case)
-
Need to connect a link display to g4 wrx4 plug inn
from can/rs232 to plug for display link
is it a can pcb lead
-
Is it crucial for this to be done when engine is running as stated in manual
I just set mines to Subaru v1-6 5 years ago and been tuned 3 times
-
-
Thanks
-
Is it possible with out plugging into car
-
Should this not be in the g4+ section not the g4
-
How do I power up a Link g4 plugin on the bench to test it
-
Adam
what connector do I require for the display link cable
Also
if i change from storm wire in to plug in unit and calibrate TPS and map once map is transferred over
is that all I need to do
-
Looking thro the pins outs on where they are on the header
have noticed the following not listed
aux output 5
aux output 7
are these available be used
also can the original link display be used with this ecu on the rs232 output on the board
-
Spoke to seller and he stated it’s a g4+
if it’s a g4 is there a manual for the pin outs
-
Hi simon or admins
just picked up an ecu listed above
can you tell me from serial number any history on it
serial number #8774 with base board v1.1 and top board rev 1.2
thanks Neil
-
Injector output is limited to about 2 amps max
EJ207 engine wiring to 2000 GC8
in G4+
Posted
Are you still running coil pack on inlet or 4 coil on plug
What injector sizes are you running
V5-6 are side feed 440cc
V7-9 sti are top feed 565cc