FIS Posted September 23, 2011 Report Share Posted September 23, 2011 Hi all, I have problem on CBR600RR, the speed reading always back to zero every time reach 150km/h. The parameter setting is pullup resistor on active edge falling calibration DI#3 3370 Anyone can help? Quote Link to comment Share on other sites More sharing options...
Guest |140| Posted September 25, 2011 Report Share Posted September 25, 2011 Hi Fis Check output auxiliary speed Multi = 1.0 Offset = ? Excuse my poor English Augusto. Quote Link to comment Share on other sites More sharing options...
bsh Posted September 26, 2011 Report Share Posted September 26, 2011 Try using the DI#1, because it should read a higher frequency than the DI#3. If I remember correctly, also the lower AUX#, the higher frequency it can output. So if you are using a AUX output higher than 1, try using AUX1 for the speedometer output. Quote Link to comment Share on other sites More sharing options...
FIS Posted October 6, 2011 Author Report Share Posted October 6, 2011 Try using the DI#1, because it should read a higher frequency than the DI#3. If I remember correctly, also the lower AUX#, the higher frequency it can output. So if you are using a AUX output higher than 1, try using AUX1 for the speedometer output. Is it? AFAIK max frequencies are same for DI#1- 4 ? Hi Fis Check output auxiliary speed Multi = 1.0 Offset = ? Excuse my poor English Augusto. I use CAN to AIM dash, the problem appeared on datalog is on input signal reading not output Quote Link to comment Share on other sites More sharing options...
Simon Posted October 7, 2011 Report Share Posted October 7, 2011 Hi Fis What firmware are you running? There have been some improvements to the speed input function in later firmware versions. Quote Link to comment Share on other sites More sharing options...
FIS Posted October 7, 2011 Author Report Share Posted October 7, 2011 Hi Fis What firmware are you running? There have been some improvements to the speed input function in later firmware versions. The one I use is 4.8.1, will try 4.8.5 very soon Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.