cHeMiCaL_ Posted June 29, 2021 Report Share Posted June 29, 2021 Hello all, need some advise, I'm setting up clutch and brake pressure sensors using linkecu press sensor part no 101-0186. Currently in PCLink G4+, there is no selection for the sensor's calibration in the drop-down menu. Does anybody has calibration table that i can refer to? Thanks much! cheers! Quote Link to comment Share on other sites More sharing options...
Vaughan Posted June 29, 2021 Report Share Posted June 29, 2021 http://linkecu.com/documentation/101-0184.jpg from the website: 0.5V = 0kPa, 4.5V = 1000kPa. the TI sensor is 1034.21kPa (150psi) at 4.5V so close but not exactly the same. Quote Link to comment Share on other sites More sharing options...
cHeMiCaL_ Posted June 29, 2021 Author Report Share Posted June 29, 2021 Just now, Vaughan said: http://linkecu.com/documentation/101-0184.jpg from the website: 0.5V = 0kPa, 4.5V = 1000kPa. the TI sensor is 1034.21kPa (150psi) at 4.5V so close but not exactly the same. Thanks much @Vaughan! but i need rather larger 140 bar / 2030psi calibration table. Hopefully i can achieve the rated accuracy from it. Quote Link to comment Share on other sites More sharing options...
Adamw Posted June 29, 2021 Report Share Posted June 29, 2021 The 140bar sensor should be setup like so: Datasheet attached 0261545053.pdf Quote Link to comment Share on other sites More sharing options...
Vaughan Posted June 29, 2021 Report Share Posted June 29, 2021 15 minutes ago, cHeMiCaL_ said: but i need rather larger 140 bar my bad, also just noticed the link to the spec sheet for the 140bar on the website doesn't work so I'll get that fixed. Quote Link to comment Share on other sites More sharing options...
cHeMiCaL_ Posted June 29, 2021 Author Report Share Posted June 29, 2021 Appreciate it so much, @Adamw!! 1 minute ago, Vaughan said: my bad, also just noticed the link to the spec sheet for the 140bar on the website doesn't work so I'll get that fixed. 1 minute ago, Vaughan said: my bad, also just noticed the link to the spec sheet for the 140bar on the website doesn't work so I'll get that fixed. Thanks again @Vaughan! Vaughan 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.